JRTD226L-AJ82A Parts List

Inlet hose washer (gasket, water inlet hose)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Cold control thermostat (temperature control thermostat assembly)

This cold control thermostat has a temperature range from 37 degrees Fahrenheit to 27 degrees Fahrenheit and a capillary length of 29 iches. This cold control thermostat cycles on and off regularly to keep your refrigerator cold.

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Egg tray

This egg tray holds fourteen eggs.

Ice bucket auger drive motor kit (motor kit, ice bucket auger drive. *mounting holes no longer threaded must order 4 new self tapping screws. See related item #596782. (cz))

This motor kit comes with a thermally protected motor, a washer and a mounting bracket. The motor performs eighteen revolutions per minute, carries 115 volts, and drives the auger for the icemaker.

Plastic tubing (1/4" plastic tubing, 8 1/2 feet long)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Screw - 6-32 x 5/16 (screw, 6-32 x 5/16)

This screw is well under an inch long, and is made of metal.

Ice maker front cover (ice maker module front cover)

Leveler (leveling leg)

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Appliance screw (screw)

Sold individually.

Water hose clamp (clamp)

These tube clamps are sold individually. The screw is not included.

Icemaker fill tube

This fill tube grommet is used to supply water to the icemaker and is partially located in the refrigerator/freezer wall.

Ice and water actuator switch

This ice and water actuator switch is an inch long. It is black on one side and white on the other. This switch is made of plastic and has two metal prongs extending from its body.

Rivet

This rivet is an inch and a half long. It is used for many washing machines, microwaves, refrigerators, dryers, and ranges. Use of this rivet requires a rivet tool.

Ejector arm (ejector arm for icemaker)

This arm is used to eject the ice from the icemaker into the bin.