CTF21GBB Hotpoint Refrigerator Parts List

Package of 12 screws (scr 8-18 ab rndw 5/8 ss)

This is a package of twelve Phillips-head screws. They can be used as replacement screws in refrigerators, ice makers, or freezers. Be sure to check that your appliance model is compatible with these screws. The screws are approximately ¾ of an inch in length.

Ice cube tray (tray ice)

14 Cube.

Defrost thermostat kit (defrost thermostat kit, 55 degrees)

This refrigerator defrost thermostat will cut out at 55 degrees F and kick back in when the temperature drops to 35 degrees F. It comes with connectors and the mounting brackets.

Evaporator fan blade kit (ring compression)

Condenser fan motor (motor cond fan)

This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.

Evaporator fan motor kit (motor evap fan)

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.

Screw (scr 12-24 ahxw 7/8 spp)

Comes 12 in a pack.

Retainer bar end cap (cap shelf frt)

Power cord (cord power)

Water tubing clip (clamp cable)

Defrost control (control defrost)

This 4-wire connection defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. You can turn the dial on the defrost timer clockwise to advance it into and out of defrost mode. If the refrigerator is too warm, the freezer section is too warm, or the freezer is not defrosting, you might need to replace the defrost timer. This defrost timer is 120-volt, 60 Hz and genuine OEM part. Pleaser remember to disconnect the power to the refrigerator before starting the repair.

Door hinge pivot (thimble seal asm)

Rear wheel (wheel mobility)

This rear wheel is sold individually. The wheel pin is not included with this roller.

Single water valve (water inlet valve for round cube icemaker, with gasket)

This single outlet valve comes with a gasket and is intended for refrigerators that have ice makers which make round ice cubes. The water inlet valve will release water from the supply line into the ice mold and from the water dispenser in the refrigerator. If the ice maker is not making or dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. This water inlet valve is a genuine OEM part. Remember to disconnect the power and water supply to your refrigerator before beginning this repair.

Door shim hinge (shim hinge btm.)

The shim hinge is located at the bottom of the refrigerator. It acts like a spacer between the refrigerator and the bottom hinge.