Repairing your YDB2210J*119 General Electric Dishwasher is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
YDB2210J*119 model diagrams below. Trust us to help you find the part you need and get your
YDB2210J*119 General Electric Dishwasher running again.
Most Popular YDB2210J*119 Parts
These are the most commonly purchased repair parts for YDB2210J*119.
-
(6)
This is a basket for washing flatware or silverware in your dishwasher. It is located on the lower rack. If your silverware basket is damaged or worn out, you should replace it. No tools are required for this repair. This basket is a genuine OEM part.
-
This water inlet valve is specially designed for those dishwashers that fit under the counter from 1974 To Present. The valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
-
-
This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.
-
(3)
The grate shaft seal, also known as drain valve shaft seal, is a seal for your dishwasher drain pump valve. The seal forms a watertight seal around the flapper valve shaft to avoid water from leaking on to the floor. The seal is black in color and measures .25” in diameter. When doing the repair, you may need to cut off the push-on nut, if so a new one will need to be ordered. Please remember to shut off the water supply and disconnect the power to the dishwasher before starting the repair. This is a genuine OEM part.
-
(2)
This pump and motor kit replaces many old style pump and motor kits that were manufactured since 1970. The instructions are included with this kit to help you to make it adaptable to your dishwasher.
NOTE: This is a completely redesigned kit by the manufacturer and now includes the drain solenoid.