Repairing your VD331C*439 General Electric Dryer is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
VD331C*439 model diagrams below. Trust us to help you find the part you need and get your
VD331C*439 General Electric Dryer running again.
Most Popular VD331C*439 Parts
These are the most commonly purchased repair parts for VD331C*439.
-
(2)
This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.
-
(2)
This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.
-
(1)
The idler pulley helps maintain the proper amount of tension on the drive belt to turn the drum. The idler pulley is located between the motor pulley and drum to provide tension on the belt. If the part has become worn, it could cause the dryer to be noisy or squeaky, and the pulley will need to be replaced. This part is yellow in color, made of plastic, and measures approximately 2 1/2” in diameter. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting the repair.
-
(1)
This part helps to keep the door closed while the machine is running.
-
There is a slot in it for a ground strap.
-
(1)
This wheel attaches to the motor.