Repairing your PDW9700N20II General Electric Dishwasher is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
PDW9700N20II model diagrams below. Trust us to help you find the part you need and get your
PDW9700N20II General Electric Dishwasher running again.
Most Popular PDW9700N20II Parts
These are the most commonly purchased repair parts for PDW9700N20II.
-
(13)
This dish rack is for dishwashers. Dish rack holds the dishes in place during the dish washing cycle.
-
(2)
This gasket lines the inside cabinet in the dishwasher.
-
(2)
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.
-
(6)
This basket is part of a silverware basket that has 3 sections. This is the middle section of the basket.
-
(9)
This includes eight rollers with axles for your dishwasher dish racks.
-
(1)
The lower spray arm is mounted to the bottom of your dishwasher tub, and it rotates and sprays water to clean the dishes in the lower dish rack. This spray arm is made of gray plastic, and is approximately 20 inches in width. The lower spray arm will not spin if it has become clogged with debris and hard water deposits from your dishwasher, if it has become jammed by silverware, causing it to melt, or if the bottom of the spray arm has become disconnected from the bottom of the tub. If the spray arm encounters any of these issues, it will need to be replaced. To replace the spray arm, remove the lower dish rack and simply unscrew the old arm. Screw the new spray arm in until it locks into place.