Repairing your PDW7912N15WW General Electric Dishwasher is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
PDW7912N15WW model diagrams below. Trust us to help you find the part you need and get your
PDW7912N15WW General Electric Dishwasher running again.
Most Popular PDW7912N15WW Parts
These are the most commonly purchased repair parts for PDW7912N15WW.
-
(13)
This dish rack is for dishwashers. Dish rack holds the dishes in place during the dish washing cycle.
-
(13)
The lower rack wheel kit includes 8 wheels and 8 axels for your rack. If your dishrack is not moving in and out of the dishwasher properly you may have a broken or missing wheel and it will need to be replaced. The wheel and axle are white in color and made of plastic. This is a genuine OEM part kit.
-
(2)
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.
-
(6)
This basket is part of a silverware basket that has 3 sections. This is the middle section of the basket.
-
This is the tub gasket replacement for your dishwasher. The tub gasket fits around the perimeter of the door and forms a seal that prevents the dishwasher from leaking when it is filled with water. If the tub gasket is loose or damaged, you may notice your dishwasher leaking. The tub gasket can wear over time, or become stretched. In either case it will need to be replaced to prevent a leak. The gasket is made of black rubber and is sold individually.
-
(1)
The lower spray arm is mounted to the bottom of your dishwasher tub, and it rotates and sprays water to clean the dishes in the lower dish rack. This spray arm is made of gray plastic, and is approximately 20 inches in width. The lower spray arm will not spin if it has become clogged with debris and hard water deposits from your dishwasher, if it has become jammed by silverware, causing it to melt, or if the bottom of the spray arm has become disconnected from the bottom of the tub. If the spray arm encounters any of these issues, it will need to be replaced. To replace the spray arm, remove the lower dish rack and simply unscrew the old arm. Screw the new spray arm in until it locks into place.