Repairing your KTRS19KMBL00 KitchenAid Refrigerator is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
KTRS19KMBL00 model diagrams below. Trust us to help you find the part you need and get your
KTRS19KMBL00 KitchenAid Refrigerator running again.
Most Popular KTRS19KMBL00 Parts
These are the most commonly purchased repair parts for KTRS19KMBL00.
-
(7)
Door switch turns the light off when you close the door.
-
(6)
This fan motor is used in frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, to cool the compressor and condenser coils. This fan motor also helps to evaporate excess water in the drain pan. This kit includes the motor, fan blade, wire harness, and screw. If your refrigerator/freezer section is too warm you may need to replace this part. This part has been updated by the manufacturer. It may look different in appearance but will still function the same as the original part. This is a genuine OEM part. Disconnect power to your refrigerator before starting the repair.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(4)
This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.
-
(11)
This ice maker kit includes everything needed to install a new icemaker in your refrigerator if it did not originally come with one. The kit includes the ice maker, ice bin, inlet valve, fill tube, hardware, 4 wire harness, connector for freezer, and instructions. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair. Note: This part has been updated by the manufacturer, it may differ in appearance but will still function the same as the original.
-
(3)
The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.