Magic Chef Stove Parts

Range Bake Element

12 Reviews

Part Number: WPY04000066

The bake element is located on the bottom of the oven cavity. This spade-style bake element has push-on wire terminals and is 16 inches wide. It has a terminal depth of three inches and a total element length of nineteen inches. If your oven is not heating evenly, the element will not heat or has little to no heat when baking, you may need to replace the element. This genuine OEM bake element comes with instructions and is intended for use with electric ovens. Please remember to disconnect the power to your oven before you start your repair.

Long Oven Sensor

4 Reviews

Part Number: 12001656

The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you may need to replace the sensor. This long oven sensor kit comes with two harness adapters and is a genuine OEM part. Please remember to disconnect the power before starting your repair.

Door Hinge

5 Reviews

Part Number: WP74008014

The door hinge attaches to the side of the door allowing the oven door to open, close, and stay open at an angle. If your door is not opening and closing correctly you may need to replace the hinge. It is recommended to replace both hinges at the same time. The hinge measures 20 1/2-inch and is made of metal. This is a genuine OEM part.

Door Hinge - Left or Right Side

Part Number: WP74011141

This hinge can be used for either the left or the right side of the oven door. Sold individually.

Door Hinge

Part Number: 74001984

This door hinge is a genuine OEM replacement part for your wall oven. Replacing this part will require partially removing your oven from the wall, to access the hinge. This part contains one hinge, although it is recommended to replace both at the same time. You will need a Phillips screwdriver to unscrew the hing assembly and install the new one.

Glass Clip - Black

1 Review

Part Number: 7112P093-60

This clip helps to hold the exterior glass in place. Order quantity required.

Bake Element (19 Inch long x 19 Inch wide)

Part Number: WP74003020

This electric oven bake element with female spade connections is 16 inches long and 19 inches wide. It has a terminal depth of three inches, making a total element length of nineteen inches.

Flat Style Oven Igniter Kit

10 Reviews

Part Number: 12400035

The flat style gas oven igniter is used to ignite the gas to light the oven burner, which produces heat for your range. If the element has shorted out, is no longer glowing, or is glowing but only orange or red rather than white, then you will need to replace the oven igniter. When replacing the igniter please be very careful not to touch the gray element part of the igniter as it is very fragile. The igniter measures approximately 3-3/4"in length and the amperage range is 3.3 to 3.6. This igniter kit can replace igniters for either the broil or bake burners and can replace shorter and longer igniters. The kit includes the igniter, 4 wire nuts, insulation, 2 wire assembly and a bracket. This is a genuine OEM part. Please make sure to disconnect the power and shut off the gas supply before starting your repair.

Bake Element

2 Reviews

Part Number: WP7406P272-60

The bake element supplies heat to the oven for baking. It is located on the bottom of the oven cavity. If your oven is too hot, the element is shorted out, or is not heating evenly you may need to replace the element. The element is made of metal and is a genuine OEM part. Please remember to disconnect the power to your range before starting the repair.

Terminal Block

2 Reviews

Part Number: WPW10245259

The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.